October 23, 2020

Samsung Dryer Not Heating But Run | Clothes Dryer Is Not Getting Hot

By intakhab Repairing, washing machain 0 Comments

Samsung runs dryer, but won’t heat up– Clothes Dryer Is Not Getting Hot (samsung dryer not heating)

Samsung Dryer Not Heating But Run

Samsung Dryer Not Heating But Run

If your Samsung dryer will spin, but not heat, a burned element may be your issue. A bad element on the Samsung dryer has been quite common with some new dryers. However, you need to do some more testing to make sure the element is not heating your Samsung dryer.

Samsung dryers may have a bad thermostat, thermal cut out fuse, closed air vent line, incorrect voltage, faulty heating element, or other internal wiring issues.

When your Samsung dryer will not heat up, make sure you have closed the vent line and the linter filter as a closed vent line will not heat your Samsung dryer properly.

Check all parts of the dryer to make sure it is not what causes it.
Check thermostats, thermal cut fuses, wiring, voltage and vent line. If you have tested all aspects of the dryer and found that the heating element is faulty, here is how to replace it.

samsung dryer not heating — Samsung Dryer Not Heating But Run

HOW TO REMOVE AND REPLACE HEATING ELEMENT FOR SAMSUNG DRYER

1. Remove power from your Samsung dryer.
2. Remove the screws on the back of the dryer.
3. Close it and remove the lid.
4. Remove the control panel by lifting upwards.
5. Remove the wire harness holding the control panel to the dryer.
6. Remove 4 screws that secure the front panel.
7. Open the dryer door and take out 2 more screws at the base of the door.
8. Depress the locking tab and remove the front panel.
9. Disconnect the door switch wire.
10. Raise the panel.
11. Disconnect the moisture sensor wiring harness.
12. Remove the screw holding the heating element housing.
13. Remove housing from mounting bracket.
14. Remove the mounting bracket screw on the base.
15. Remove mounting bracket.
16. Pull the heating element housing out of the dryer.
17. Disconnect the wire harness from the heating element.
18. Do not remove the wire harness from the thermostat or high limit switch.
19. Remove the screws holding the thermostat and the high limit switch from the housing.
20. Remove the screws holding the heating element housing together.
21. Tilt the tab upward and separate the heating element housing.
22. Straighten the wire terminal locking tab and remove the wire terminals and heating element from the housing. Samsung driver heating element to test = (Use the meter at two ohm, to tell if the element is bad, so you know to make sure the dryer is not the cause.)
23. Replace the faulty heating element with the new heating element and put everything back together using this guide upside down.

samsung dryer not heating, samsung dryer runs but does not heat

Samsung Dryer Heating Element Replacement
Instructions for replacing the heating element on your Samsung dryer.
The dryer does not heat up, gets too hot, is too long, travels on the breaker, or does not stop heating.
How does the heating element in a Samsung dryer work?
The Samsung heating element DC47-00019A works when the motor is switched on. The element will then reddish and heat the dryer. When the dryer drops below a certain temp, the element turns on and starts heating the dryer once again. This cycle will repeat until completion and the clothing dries.
Why did the heating element on my Samsung dryer go bad?
If your dryer heating element is burnt or defective, something else within the dryer may cause it. Check vent exhaust for lint clogs. The issue of a lint blockage can burn your heating element.
What else can my Samsung dryer cause?
Check the thermostat and the high limit cut fuse to ensure that those components are not overheating the dryer. See below…

This Samsung dryer heating element will work on clothes dryer model number:

samsung dryer not heating

DV306BEW, DV306LEW, DV316BEC, DV316BEW, DV316HEC, DV316LES, DV316LEW, DV317AEG, DV317AES, DV317AES, DV38AEG, DV328AER, DV328AER, DV326AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER, DV328AER DV337AEW, DV338AEW, DV339AEG, DV339AEL, DV339AER, DV339AES, DV339AEW, DV340AEG, DV340AER, DV350AEG, DV350AEP, DV350AER, DV350AEW, DV393ETPARA, DV393ETPAWR, DV395ETPARA, DV395ETPAWR, DV3C6BEW, DV405ETPASU, DV419AEW, DV428AEL, DV428AEW, DV431AEP, DV431AEW, DV438AEL, DV438AER, DV448AEE, DV448AEP, DV448AEW, DV456EWHDWR, DV484ETHASU, DV484ETHAWR, DV501AEW, DV5451AEP, DV5451AEW, DV218AES, DV218AEW, DV219AEB, DV219AEW, DV220AEW, DV221AEG, DV221AES, DV229AEG, DV231AEW, DV2C6BEW, MDE6700AYW, DV5471AEP, DV5471AEW, Bed70b, BED70W, DV203AES, DV203AEW, DV206AES, DV206LEW, DV209AEW, DV210AES, DV21018, DV218AEB, MDE6700AZW, MDE9700AYM, MDE9700AZW, MDE9700AZM, MDE9700AZM, MDE9700AZ, DVE4, DVE4, DVE4A10, DVE4A10, DVE4, DVE10, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVA4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE4, DVE2, DVE2, DVE2, DVE2, DVE2, DVE2, DVE2, DVE2, DVE2, DVE2, DVE2 0TW.

Need help replacing the heating element on your Samsung dryer? Please leave a question below and we‘ll write back with the easiest ways to replace your dryer heating element or any other part.

ALSO READ THIS