Aerotek Air Conditioner Error Codes
Aerotek Air Conditioner Error Codes
Aerotek Air Conditioner Error Codes
Aerotech produces climate equipment that does not The modern world is inferior to analogs and has fairly reasonable prices.All products are distinguished by the optimal “price-quality” ratio. forAir conditioners of this brand are used to produce components High quality only. Therefore, for all the company’s equipment The warranty is 3 years. Aerotech’s air-conditioner has a high degree of reliability.
E0 – There was an error in determining the water flow rate;
E1 – An error Happened while adding steps;
E2 – A communication error has Happened;
E3 – There was a fault in the temperature sensor of the cooling liquid at the outlet;
E4 – Water temperature sensor error Happened while exiting
Shell-and-tube heat exchanger;
E5 – An error Happened in the temperature sensor of the capacitor A’s tubes;
E6 – There was an error in the temperature sensor of the tubes of capacitor B;
E7 – An error Happened in the outdoor temperature sensor;
E8 – An error Happened in the tem. sensor in the discharge line Compressor system A;
E9 – An error Happened while determining the flow of water;
EA – The main unit reported a decrease in the number of additional blocks;
EB An error Happened in the temperature sensor of the-protection system
Freezing of heat exchanger;
European Union – One of the modular units has no output;
ED There was a communication error between the-modular unit and the drive controller;
Aid – protection of power supply;
EE – There was a communication error between the computer and the drive controller;
EF – An error Happened in the temperature sensor at the inlet water;
P0 – The injection line of System A had an overheating;
Р1 – System A had a decrease in pressure;
P2 – There was an over temperature in the injection line of System B;
P3 -The B system had a decrease in pressure;
P4 – Overcracked in System A;
P5 – Overcracked in System B;
P6 – The pressure in the condenser of system A was increased;
P7 – The pressure in the capacitor of system B is increased;
P8 – Temperature sensor errors in discharge line Happened
Compressor system A;
P9 – protection against water temperature differences at the outlet and inlet;
RA – protection against supercooling during start-up;
KBB – There was a frost;
PE -The shell-and-tube heat exchanger was supercooled;
F1 – Errors in permanent memory;
F2 – Errors Happened while connecting wired controllers.
ALSO READ THIS
About Author
