Delonghi Portable Air Conditioner Fault Codes Solution

Delonghi Portable Air Conditioner Fault Codes | Solution

Delonghi error code solution Delonghi Portable Air Conditioner Fault Codes Error code what should i do


LE low temperature (frost prevention). The equipment is fitted with a frost protection device to avoid excessive formation of ice. The equipment restarts automatically when the defrosting process is complete.


HL high level (internal tray complete). Empty the internal safety tray following the instructions in the “End of Season Operation” section. If it reoccurs in cooling mode, contact your local authorized customer services. In heating mode: Empty the internal tray.


CF Replace Filter. When this message is displayed, the water filter needs to be replaced as described in the section: “Replacing the Limescale Filter”.


PF probe failure (sensor damaged). If it is displayed, contact your local authorized service center.


F1 Failure 1. This message may appear if the water filter is particularly full. See the section: “Replacing Limescale Filters”. If the filter has recently been changed, contact your local authorized service center.


Low temperature – room temperature is too low.


H1 High Temperature – Room temperature is too high.


E1 probe failure (sensor damaged).


The device has a self-diagnosis system to identify multiple malfunctions. Error messages are displayed on the instrument display.

Delonghi Portable Air Conditioner Fault Codes
Delonghi Portable Air Conditioner Fault Codes, Delonghi error code solution

Delongi Portable Air Conditioner Error Code – Le HL CF PF F1

Troubleshooting


Problem: Air conditioner does not come on

reason:

  1. There is no current
  2. It is not plugged into the main
  3. Internal protection device is tripped

Solution:

  1. Wait
  2. Plug in main
  3. Call the service center

Problem: Air conditioner only works for a short time

reason:

  1. The air exhaust pipe has twists or kinks
  2. Preventing some air from being discharged

Solution:

  1. Keep the air duct properly, keep it as low and free as possible to avoid bottlenecks.
  2. Check and remove any obstruction obstructing the air discharge

Problem: The air conditioner works, but does not cool the room

reason:

  1. Open windows, doors and / or curtains
  2. There are heat sources in the room (oven, hairdryer, etc.)
  3. The air exhaust pipe is separated from the equipment
  4. Clogged Dust Filter

Solution:

  1. Doors, windows and curtains above, keeping in mind the “suggestions for correct use” above.
  2. eliminate heat sources
  3. Fit the air exhaust hose into the housing behind the equipment
  4. Clean or replace the filter as described above

Problem: During the operation, there is an unpleasant smell in the room

Reason: Dust filter and (when present) electrostatic filter clogged

Solution: Clean the filter as described above


Problem: The air conditioner does not work for about three minutes after starting it again

Cause: The internal compressor safety device prevents the appliance from starting again until it is last switched off.

Solution: Wait. This delay is part of normal operation.


Issue: The symbol and one of the following messages appears on the LT / HL / Cf / PF / FI device display:

Reason: The device has a self diagnosis system to identify multiple malfunctions.

Solution: See the SELF-DIAGNOSIS chapter.

Delonghi Portable Air Conditioner Fault Codes
Delonghi Portable Air Conditioner Fault Codes, Delonghi error code solution

Delonghi Portable Air Conditioner Fault Codes
Delonghi Portable Air Conditioner Fault Codes, Delonghi error code solution

Delonghi Portable Air Conditioner Error Code

“CF” is displayed when the limescale filter needs to be replaced. The efficacy of the filter depends on the hardness of the water. However, it should be replaced every five years.

Delonghi Portable Air Conditioner Fault Codes
Delonghi Portable Air Conditioner Fault Codes, Delonghi error code solution
Delonghi Portable Air Conditioner Fault Codes
Delonghi Portable Air Conditioner Fault Codes, Delonghi error code solution

If the remote control unit is replaced or abandoned, the batteries must be removed and disposed of according to current law as they are harmful to the environment. Do not mix old and new batteries. Do not mix Alka line, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Do not dispose of the battery in a fire. Batteries may explode or leak.

Netflix DNS Codes Updated 2020

 

 

Share and Enjoy !

Shares
9 Comments

Add a Comment

Your email address will not be published. Required fields are marked *